Key Specs: Production Rate 200 loads per hour Machine Dimensions 18″, 24″, 36″, 48″ or 60″ diameter ring Other ring sizes available Machine dimensions depending on ring size Load Weight Maximum load weight limited to conveyor capacity Electrical Requirements 230 V / 3 ph / 60 Hz 15 A Pneumatic Requirements 3 cfm @ 80 psi Controls Allen Bradley Micrologix 1200 PLC Automatic cut & clamp system 24V control system Top hold down activation photoeyes (if applicable) Start / stop push button Auto/Manual/Continuous mode Current overload protection NEMA 4/12 control cabinet with quick disconnect Power on/off switch and indicator pilot light Large emergency stop (push / pull type) End wraps selectors (1-2-3) Push button to activate film cut & clamp Foot pedal ring activation or load release UL approved components and UL508A control panel Automatic Operation Communication package with entrance & exit conveyor, cut & clamp sequence occurs upon clearance of the exit photoeye OR Load release by foot pedal and powered conveyor, cut & clamp sequence occurs upon clearance of the exit photoeye When load is fed by conveyors controlled by Wulftec, machine comes with a push button for banding mode Manual Push Through Operation Foot Pedal activates ring rotation Entrance and exit photoeyes activate top hold down (if applicable) Push button must be depressed for cut & clamp sequence** Continuous cycle mode available Film Delivery System 5″ to 10″ film carriage. (Film core diameter 3″) Manual film tension adjustment directly on carriage Quick and easy film roll change Can be used with pre-stretched film for more cost savings Film Tail Treatment Automatic film cutting & clamping (can also be activated manually) Structure All structural steel design Fully guarded frame Electric interlocked access door Drive System RPM based on ring size (80 RPM on a 36” ring) AC motor with variable frequency drive Aluminum ring driven by a flat belt allowing higher speeds Maintenance free vertical polyurethane guiding wheels with sealed bearings Electronic soft start/stop Positive ring alignment controlled by proximity sensor Electric brake system Safety Features 1 E-Stop mushroom type push button on control panel (Additional E-Stops are available upon request*) Wrapping zone enclosed with an electronically interlocked access door Conveyor A large variety of gravity and powered conveyors are available. (Chains, belts, v-belts, roller, etc.) Technical Information The machine is provided with a manual including electro/mechanical schematics and drawings, troubleshooting guide and installation instructions